GET STARTED HERE!

Monday, November 16, 2020

Brand New Video - How to Use your Tilt Stand and Tilt Safe Brackets

When I taught the Rib It! seminar, the knitters really noticed my tilt stand and how I use it.  There are a lot of advantages to them:

  • Tilt stands are very sturdy.  I have had really old ones (like 30+ years) and they are still rock solid.
  • Tilt stands don't rock or wiggle.  The four legs are spread for a wide base.  The legs have thick rubber pads on the ends that stay put.
  • These stands have a holder in the back for the lid of your knitting machine case.  That lid holds a lots of miscellaneous necessities for machine knitting.  Mine are chock-full of items, and I'm grateful to have them right there within reach.  I might have to stand up and peer over the back of the machine, but this holds a lot more tools and books than a flat table, unless you have an enormous flat table.
  • Tilt stands have a relatively small footprint.
  • If you want them taller, you can put each leg on a bed riser and then stand to knit.  I just put them on the floor, and use an adjustable office chair that I move up and down to change my body position from time to time as I knit.
  • They are just the right thickness to hold machine clamps.
  • They're expensive, but you can find them used, since they last so long.
  • Best of all, you can go from slanted operation with your ribber to flat and back again in seconds!
I was surprised at how many questions I got about tilt stands.  This new video covers those questions.

Also, I originally had the very old style ones, which did not have a security bracket to hold the clamps. When I treated myself to a new one I discovered that the new ones come with these brackets.  I promptly decided that the safety brackets are an absolute necessity.  Without them, with the stand tilted, you could have your machine slip right off onto the floor or your lap!  The machine is both fragile and heavy.

Other people had the same thought.  Ronnie in Chicago has a source for these safety clamps that I put in the video description, below the video on YouTube.  The ordering links are here, as well:

https://twistedyarns.com/patterns/tiltsafe-brackets-for-one-inch-tube-stand/


There are two sizes, 1" and 2", so look at your stand and see which ones you need.  I do not have an affiliation to "feature" these items - I simply am very happy with the 1" ones I bought and I want to spread the word and support vendors who are willing to manufacture items we need and can't get elsewhere!

Important: Do not overtighten your machine clamps!  Gradually, over-tightened clamps spread and then no longer hold the machine securely.  I don't have great grip strength, and to tighten them, I grab a short dowel or chopstick for a little leverage.  You could use a screwdriver shaft or a longer stick, but don't overdo it!  Also, I avoid using the racking handle for tightening.  It is probably strong enough, but I'd hate to damage it.

No comments:

Post a Comment